Self Contained, High Flow, Hot Water, Aircraft Safe Pressure Washing System with Built-in Foamer and Engine Flushing

DOWNLOAD SPECIFICATION SHEET

The TAWS™ is a low pressure, 175 PSI maximum pressure, hot water washer with built in high capacity foamer and integrated turbine engine flush kit with connection tools to support a wide range of on-wing engine flushes. Also includes integrated air compressor to close bleed bands, drive pneumatic tools, cockpit blow down or support any compressed air requirements. Supports 1-3 operators to speed aircraft cleaning operations.

Safe Aircraft temperature (140 degree water) plus aircraft safe medium pressure (175 PSI) combined with high flow, (5 GPM per gun) provides unequaled washing efficiency for aircraft wash/rinse/decontamination. Built in high flow foamer will cover the side of a CH47 in less than a minute. Dual gun for two users and 200’ of total reach to make set-up a snap and speed cleaning and rinsing operations. All hoses are on reels, all guns have storage brackets and toolbox for storage.

Tow with HMMV, TUG, or other common AGE, 6” to 28” tow bar height, stout fully boxed trailer construction with 7000# axle set. Recessed 12V/24V LED lighting and NATO standard plug makes transport simple.

- Self contained and stand alone  
- 525 Gallon supply tank
- 10 Gallon soap concentrate tank
- 10 Gallon gas path solution tank
- 14.5 HP Water Cooled Kubota Diesel
- Runs on Military standard fuels (JP-8)
- Tier IV certified
- Cleanable desert K&N air filter
- Down directed exhaust
- Optima™ Red Top AGM battery
- 18 gallon fuel tank
- Min 8-hour engine run time operation
- Complete instrumentation
- Air transportable with 6 tie down rings
- DOT trailer w/parking brake & NATO Plug
- 12-volt system wiring
- On board storage for all tools and spares

Combines 3 Essential Aircraft Ground Support Assets... ON ONE FRAME
Aircraft Wash & Rinse, High Volume Foamer and Turbine Engine Flush.

- Dual direct drive heavy duty CAT® pumps
- Run dry protection w/auto shut off
- Independent operator wash/rinse controls
- Independent heaters for hot water to 140F
- Selectable hot or cold water
- Built-in high capacity foamer, 44 GPM
- Auto-mix most soaps from concentrate
- Integrated 125 PSI air compressor, 8.7 CFM
- Pre-plumbed air purge of all lines and fittings for freeze protection
- Built-in Turbine Engine Flush, approved for CH-47, OH-58, UH-60 and AH-64
- Includes standard connection fittings and tools
- Complete custom steel tube frame  construction
- MIL-STD 810F painted with 2 part epoxy
- Adjustable Lunette Eye receiver with 6” to 28” travel
- Goodyear® Kevlar® reinforced tires with spare

Part Number AWS/TAWSP10175DT/M
Dry weight: 2450#
l/w/h: 168” x 78” x 72”
Distributed by: PellTech Solutions
Cage: 5RXS8